(No.YA011)1-21
4.5.7 SETTING METHOD OF SUB MENU SCREEN
4.5.7.1
1. IF [Perform only confirmation]
When enter to the 1. IF adjustment screen, display the sub select
screen as shown in figure. Then select the one of 1.VCO or 2.
ATT with CHANNEL number key on the remote control unit.
1. VCO screen
1) VCO condition
Display the VCO condition. The letter where yellow arrow points
is current VCO condition.
2) Exit
Press the [INFORMATION] key twice to exit to the service menu.
4.5.7.2
2. V/C, 4. DEF and 5. VSM PRESET
The operation method in each screen is almost the same.
1) Setting item
Press the [FUNCTION (UP/DWON)] key to select the setting
item.
2) Setting value
Press the FUNCTION (RIGHT/LEFT)] key to adjust the value.
3) Memorize
Press the [MENU] key to memorize the adjustment value.
4) Exit
Press the [INFORMATION] key twice to exit to the service menu.
2. V/C
4. DEF
5. VSM PRESET
4.5.7.3
3. AUDIO, 6. STATUS, 7. 3DNR, 8. IP, 9. SHIPPING and 0. BUS FREE
It is no requirement for adjustment. Do not change the values in these sub menu screen.
1-2:SELECT i : EXIT
IF SERVICE MENU
1. VCO
2. ATT ON / OFF
i : EXIT
VCO(CW) **.**MHz
MAIN
TOO HIGH
ABOVE REF.
JUST REF.
BELOW REF.
TOO LOW
VCO condition
Yellow arrow
Exit key
V / C N3
1.CUT_OF_R 130
****************
- / + : STORE i : EXIT
MENU
Setting item
1.CUT_OF_R~15.RY ANGL
Setting value
Exit from this mode
Memorize the value
DEF FULL 1125i
1. FREE-RUN 0
- / + : STORE i : EXIT
MENU
( 93)
Select the setting item
1.FREE-RUN~11.V-LIN
Setting value
Exit from this mode
Memorize the value
VSM PRESET BRIGHT
1. CONT 16
- / + : STORE i : EXIT
MENU
Setting value
Setting item
CONT~WDR B
Exit from this mode
Memorize the value
