1-6
HX-Z3
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
Disconnect the card wires from connector CN44 and
CN870 on the main board on the right side of the
body. Remove the screw D attaching the wire from
extending from the underside of the front panel
assembly.
Disconnect the wire from connector CN701 on the
bridge board.
Cut the tie band.
Disconnect the wires from connector CN231 and
CN232 on the primary board on the left side of the
body and remove the band fixing the wire.
Remove the plastic rivet attaching the inner bar in
the center of the front panel assembly.
1.
2.
3.
4.
5.
Remove the three screws E attaching the front
panel assembly at the bottom of the body.
Release the two joints a on the lower left and right
sides of the front panel assembly using a
screwdriver, and remove the front panel assembly
toward the front.
6.
7.
Removing the front panel assembly
(See Fig.6 ~ 9)
Front panel need to be tilt a little bit as release
from bottom chassis.
REFERENCE:
Keep the plastic rivet for reuse.
REFERENCE:
Front panel assembly
Front panel assembly
Front panel assembly
Front panel assembly
Fig.6
Fig.7
Fig.8
Fig.9
Bridge board
CN701
Bridge board
CN701
Main board
CN870
D
E
Joint a
Joint a
Primary board
CN231, CN232
Primary board
CN231, CN232
Plastic rivet
Band
Inner bar
Bottom chassis
CN44
CN922
