1-10
HX-Z3
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly, the rear panel, the antenna board and
main board.
Remove the plastic rivet attaching the stay inner bar
and remove the screw H on the bridge board.
Move the inner bar forward and upward to release
from the front section (joint f) and from the bridge
board (two joints g) respectively.
Remove the two plastic rivets setting the holding
board fixing the bridge board and the primary board.
Move the bracket board in the direction of the arrow.
Disconnect the wire from connector CN212, CN213
and CN214 on the primary board respectively and
remove the band attaching the wires.
Disconnect the wire from connector CN701 on the
bridge board.
Remove the two screws I attaching the heat sink
bracket and move the heat sink in the direction of the
arrow to release from the base chassis (two joints i).
The bridge board and the regulator board come off
with the heat sink.
1.
2.
3.
4.
5.
6.
Removing the bridge board / regulator
board / heat sink (See Fig.22 ~ 27)
Fig.23
Fig.25
Fig.24
Inner bar
Inner bar
Plastic rivet
Bridge board
Bridge board
Regulator board
H
Plastic rivet
Fig.22
Joint g
Joint f
Bridge board
CN701
Primary board
CN213
Tie band
Primary board
CN214
Heat sink
Heat sink bracket
I
I
CN213
CN212
CN212
CN214
