Masterpage:Right-No-Heading
29
Filename [XVS30EK_07S-VHS.fm]
Page 29
September 25, 2003 4:16 pm
A
Select the S-VHS deck.
On the unit
Press
VCR/DVD
repeatedly so that the VCR indicator
lights up.
On the remote control
Press
VCR
so that the VCR indicator lights up.
B
Select the L-2 SELECT mode.
Set “L-2 SELECT” to “A/V” or “SAT”. (
●
When you select “SAT”, refer to “IMPORTANT” on page 62.
C
Set the tape speed.
Press
p
.
D
Engage the Automatic Satellite Programme
Recording mode.
On the unit
Press and hold
SAT
#
for
about 2 seconds.
On the remote control
Press and hold
REC LINK
for about 2 seconds.
●
The “
N
” and “
#
” indicators
light up and the unit turns
off automatically.
NOTES:
●
Operations on the DVD deck are not possible when the
Automatic Satellite Programme Recording mode is engaged or
timer recording is in progress.
●
To disengage the Automatic Satellite Programme Recording
mode, press
REC LINK
. The “
N
” indicator goes off.
●
If the unit’s power is off, it is not possible to engage the
Automatic Satellite Programme Recording mode.
●
In step
D
, if the “
N
” indicator does not light but instead blinks
quickly even though your satellite receiver’s power is off,
Automatic Satellite Programme Recording will not work
properly with that satellite receiver*. If this is the case, perform
“Express Timer Programming” (
墌
pg. 26) to timer-record a
satellite programme.
* Some satellite receivers output signals even if the power is off.
Automatic Satellite Programme Recording is not possible with those
satellite receivers.
●
The “
N
” indicator blinks while Automatic Satellite Programme
Recording is in progress.
●
For timer programming of the satellite receiver, refer to the
instruction manual of the satellite receiver.
●
Automatic Satellite Programme Recording is not possible if
your satellite receiver does not have a timer.
●
Pressing the unit’s
1
button while Automatic Satellite
Programme Recording is in progress turns off the unit’s power
and disengages the Automatic Satellite Programme Recording
mode.
●
If there are more than one satellite programmes you wish to
record with Automatic Satellite Programme Recording, it is not
possible to set different tape speeds for each programme.
●
Depending on the type of satellite receiver, the unit may not
record a slight portion of the beginning of the programme or
may record slightly longer than the actual length of the
programme.
●
If you engage the Automatic Satellite Programme Recording
mode when the satellite receiver’s power is on, the unit will
not start Automatic Satellite Programme Recording even
though the “
N
” and “
#
” indicators blink. When the satellite
receiver shuts off once and is turned back on again, the unit
starts recording.
●
You can also record a programme from your cable system in
the same way if the system has a timer.
●
The B.E.S.T. system (
墌
pg. 23) does not work while Automatic
Satellite Programme Recording is in progress.
●
Just Clock (
墌
pg. 77) does not work when the Automatic
Satellite Programme Recording mode is engaged.
Before performing the following steps:
●
Make sure the satellite receiver is connected to the unit’s
L-2 IN/DECODER connector. (
●
Programme the timer on the satellite receiver.
●
Insert a cassette with the safety tab in place.
●
Slide the
TV/VCR/DVD
switch to the right.
XVS30EK_07S-VHS.fm Page 29 Thursday, September 25, 2003 4:18 PM
