subsidiary information
57
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
RECORDING
1. Recording cannot be started.
2. TV broadcasts cannot be
recorded.
3. Tape-to-tape editing is not
possible.
4. Camcorder recording is not
possible.
5.
U
and
,
on the display panel
won’t stop blinking.
TIMER RECORDING
1. Timer recording won’t work.
2. Timer programming is not
possible.
3.
c
on the display panel won’t
stop blinking.
4.
c
,
U
and
,
on the display
panel won’t stop blinking.
5.
c
blinks for 10 seconds and the
Timer mode is disengaged.
6. The VIDEO Plus+ system does
not timer record properly.
• There is no cassette loaded, or
the cassette loaded has had its
record safety tab removed.
• L-1, L-2 or F-1 has been selected
as the input mode.
• The source (another VCR,
camcorder) has not been
properly connected.
• All necessary power switches
have not been turned on.
• The input mode is not correct.
• The camcorder has not been
properly connected.
• The input mode is not correct.
• The end of the tape was
reached during Recording.
• The clock and/or the timer
have been set incorrectly.
• The timer is not engaged.
• Timer recording is in progress.
• The timer is engaged but
there’s no cassette loaded.
• The loaded cassette has had its
record safety tab removed.
• The end of the tape was
reached during timer recording.
•
c
has been pressed when
there are no programs in
memory, or the timer record
information has been pro-
grammed incorrectly.
• The VCR’s preset positions
have been set incorrectly.
Insert a cassette, or using
adhesive tape, cover the hole
where the tab was removed.
Set to the desired preset.
Confirm that the source is
properly connected.
Confirm that all units’ power
switches are turned on.
Set the input mode to L-1, L-2 or
F-1.
Confirm that the camcorder is
properly connected.
Set the input mode to L-1, L-2 or
F-1.
The programme may not have
been recorded in its entirety. Next
time make sure you have enough
time on the tape to record the
entire programme.
Re-perform the clock and/or
timer settings.
Press
c
and confirm that
c
is
displayed on the display panel.
Timer programming can’t be
performed while a timer recording
is in progress. Wait until it
finishes.
Load a cassette with the record
safety tab intact.
Remove the cassette and cover
the hole with adhesive tape, or
insert a cassette with the record
safety tab intact.
The programme may not have
been recorded in its entirety. Next
time make sure you have enough
time on the tape to record the
entire programme.
Check the programmed data and
re-programme as necessary, then
press
c
again.
Refer to
Guide Program Numbers
(
墌
pg. 54) and re-perform the
procedure.
HR-S6955EK-EN/p53-59
3/18/02, 03:48 PM
57
Summary of Contents for HR-S6955EK
Page 12: ...three step quick start 12 ...
Page 28: ...basic features 28 ...
