CONTROLS, INDICATORS AND CONNECTORS
12
Rear Section
1
Back tally lamp
This lamp lights up when the GY-HD250/GY-HD251 enters
the record mode. It blinks during the transition to the
record mode.
When the tape has run out, or the VTR enters the warning
mode, it blinks quickly.
• Use the BACK TALLY item on the OTHERS[1/2] menu
screen to select whether or not the lamp should light
and the lighting pattern.
X
See page 96.
2
[PHONES] Earphone jack
This is a stereo mini-jack for connecting an earphone for
audio monitoring. Plug in an earphone or headphone with
a 3.5 mm diameter plug. The earphone can also be used
to monitor alarm tones in accordance with the circum-
stances.
The audio channel to be output is selected with the AUDIO
MONITOR item on the AUDIO/MIC[2/2] menu screen and
MONITOR SELECT switch
d
on page 19.
The audio output level is adjusted with the Audio monitor
volume control
3
on page 14.
MEMO
• The volume of the alarm sound is set with the ALARM
VR LEVEL item on the OTHERS[1/2] menu screen.
• When using a stereotype jack and stereo sound should
be output, the following setting should be performed.
Set the MONITOR SELECT switch
d
on page 19 to
BOTH.
Set the AUDIO MONITOR item on the AUDIO/MIC[2/2]
menu screen to STEREO.
Connecting the Earphone Cable
To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure below.
• Attach the clamp filter as close to this device as possible,
as shown in the figure.
3
Shoulder belt hooks
Allows you to attach a separately sold shoulder belt.
4
LCD monitor
Shows a color camera image or the VTR playback picture.
It is also used for displaying the following:
• Menu Setting screens
• Characters showing the whether the GY-HD250/GY-
HD251 is set to shooting mode or VTR playback mode
• Date and time and time code
• Audio level meter
• Warning indications, etc.
X
See page 22.
1
2
3
4
Earphone cable
Clamp filter
e_hd250.book Page 12 Tuesday, October 24, 2006 3:11 PM
