1-1 (No.86700)
SECTION 1
JIGS AND TOOLS
1.1
TOOLS REQUIRED FOR ADJUSTMENTS
Fig.1-1-1
1. Torque driver
Be sure to use to fastening the mechanism and exterior parts
because those parts must strictly be controlled for tightening
torque.
Torque setting value of torque driver is limited. At the values
over the maximum torque setting value, fasten a screw
manually not to damage the screw thread.
2. Bit
This bit is slightly longer than those set in conventional torque
drivers.
3. Tweezers
To be used for removing and installing parts and wires.
4. Chip IC replacement jig
To be used for replacement of part.
5. Slit washer installation jig
To be used to install slit washers.
6. Cleaning cloth
Recommended cleaning cloth to wipe down the video heads,
mechanism (tape transport system), optical lens surface.
Torque driver
YTU94088
1.
Bit
YTU94088-003
2.
3.
Chip IC replacement jig
PTS40844-2
4.
Tweezers
P-895
Slit washer installation jig
YTU94121A
5.
6.
Cleaning cloth
KSMM-01
