JVC DT-V9L5, Instructions Manual

Page: 19 / 228

17
EN EN
Scope Setting*
1
Configure the settings for the wave form monitor and vector scope.
Item To do Setting value
Gain* 2 Adjust the input gain level. –10 to +10
Size*
3
Set the window size. Normal, Large
Position Select the window position. Lower Right, Lower Left
Upper Left, Upper Right
Transparent Activates/deactivates the function to make the window translucent. Off
On
Off
On :
: Normal
Translucent
Auto Off Set the function to turn off the window automatically 15 minutes after displayed. Off, On
Histogram Display Select the signal component for the histogram display. Y, R, G, B
Wave Display Select a wave form to be displayed for the wave form monitor. Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
Wave Filter Turn on/off the lowpass filter to put over the input wave form data. Flat (No filter)
Lowpass
Wave Over Level Marking Turn on/off the function to change the wave form color of signals over the value
specified in “Wave Over Level”. (
☞
below)
Off, On
Wave Over Level Adjust the lower limit for the over level. 70 – 109
Example of the histogram display
Example of the wave form monitor
Ex.: When the luminance signal is Y, “Wave Over Level Marking” is set to “On” and
“Wave Over Level” is set to “80”
Example of the vector scope
Ex.: When the color bar is
displayed
• The wave form color of signals over the value specified in “Wave Over Level”
turns red.
• The display differs depending on the input signal or the “Wave Display” setting.
*
1
The vector scope is not displayed when the input signals are RGB.
*
2
Unavailabe for the histogram.
*
3
Only “Normal” is available for the histogram.
Start End
Red White
Y
Image signals
DT-V9L5_EU_EN_1.indb 17 DT-V9L5_EU_EN_1.indb 17 10/10/2012 3:51:01 PM 10/10/2012 3:51:01 PM