Masterpage:Right-No-Heading
EN
93
Filename [DR-M10SE_11Subsidiary.fm]
Page 93
February 12, 2004 5:31 pm
AUDIO OUTPUT
(The
boldface
settings in the table below indicate the settings at your purchase.)
8
DIGITAL AUDIO OUT
DOLBY DIGITAL/PCM
STREAM/PCM
PCM ONLY
Set to the appropriate mode according to the type of the device connected to
DIGITAL OUT connector.
DOLBY DIGITAL/PCM
:
Select this when you connect the digital input connector of a Dolby
Digital decoder or an amplifier with a built-in Dolby Digital
decoder.
STREAM/PCM
:
Select this when you connect the digital input connector of an
amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel
decoder.
PCM ONLY
:
Select this when you connect the linear PCM digital input of other
audio equipment (amplifier, MD or DAT deck, etc.).
8
ANALOG AUDIO OUT
STEREO
DOLBY SURROUND
Select the appropriate setting to accommodate the unit to the connected A/V
equipment. This function takes effect when a DVD VIDEO disc is played back.
STEREO
:
Select this when listening to conventional two-channel stereo audio
with the unit’s AUDIO OUT connectors connected to a stereo
amplifier/receiver or TV set, or in case you want to record the audio
from a DVD VIDEO disc to a Mini Disc, etc.
DOLBY SURROUND
:
Select this when listening to multichannel surround audio with the
unit’s AUDIO OUT connectors connected to an amplifier/receiver
with a built-in surround decoder or a surround decoder.
8
D. RANGE CONTROL
NORMAL
WIDE RANGE
TV MODE
The dynamic range (the difference between the loudest sound and the quietest
one) can be compressed during playback of a programme encoded in Dolby
Digital format.
This function takes effect when a DVD VIDEO disc recorded in Dolby Digital
format is played back at low or middle volume.
NORMAL
:
Normally select this setting to activate this function.
WIDE RANGE
:
Select this to deactivate this function when you enjoy wide dynamic
range programme.
TV MODE
:
Select this when you hear the sound through the TV’s speaker(s).
NOTES:
●
This function takes no effect on programmes other than that recorded in Dolby Digital
format.
●
This function dose not work when Simulated Surround Effect is activated. (
墌
pg. 44)
●
The effect of “NORMAL” and “WIDE RANGE” may not be different depending on discs.
8
OUTPUT LEVEL
STANDARD
LOW
You can lower the output level of analog audio to accommodate the unit to the
connected A/V equipment.
STANDARD
:
Normally select this setting.
LOW
:
The output level of analog audio is lowered.
DR-M10SE_01.book Page 93 Thursday, February 12, 2004 9:08 PM
