JVC CA-MXK50R, Instructions Manual

Page: 10 / 38

– 7 –
1
Press and hold the clamp of the AM terminal
on the rear of the unit.
2
Insert the end of the AM (MW/LW) loop
antenna cord into the terminal.
• If the AM (MW/LW) loop antenna wire is
covered with vinyl, remove the vinyl by
twisting it as shown in the diagram.
3
Release the finger from the clamp.
4
Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM terminal and extend it horizontally. (The AM
(MW/LW) loop antenna must remain connected.)
For better reception of FM, MW, and LW
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors): Red (+) to red (+) and black
(–) to black (–).
• If the wire is covered with vinyl, remove
the vinyl by twisting it as shown in the
diagram.
3
Release the finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the
unit.
• DO NOT connect more than one speaker to one speaker
terminal.
6-16
[ ]
SPEAKER
AM (MW/LW) antenna
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop
antenna (supplied)
Connecting Speakers
From left
speaker’s
terminals
Speaker
cord
(red/black)
From right
speaker’s
terminals
ANTENNA
FM 75 AM
[ ]
Black
Red
1
2, 3
1
2, 3
Speaker
cord
(red/black)
01-10.MX-K50R[B].pm6 02.4.12, 4:41 PM 7