JVC CA-FSY1, Service Manual

Page: 20 / 64

1-20 (No.MB376)
3.2.6 Attaching the pickup
(See Figs.4,6 to 9)
• See "3.2.5 Removing the pickup".
(1) Attach the shaft, SW actuator and lead spring to the pickup.
(See Fig.8.)
(2) Align the pickup to the section n of the traverse mechanism
assembly first and set the both ends of the shaft of the pick-
up in the sections (
k , m) of the traverse mechanism assem-
bly. (See Fig.7.)
Note:
When attaching the shaft to the section m , attach it under
the torsion spring. (See Fig.7.)
(3) Attach the plate and thrust spring. (See Fig.6.)
(4) Remove solders from the short land sections
d after con-
necting the card wire to the connector on the pickup. (See
Figs.4 and 6.)
(5) Turn the feed gear M in the direction of the arrow 1 to move
the pickup in the direction of the arrow 2. (See Fig.9.)
Fig.8
Fig.9
Pickup
SW actuator
Lead spring
F
Shaft
Feed gear M
Pickup
1
2