(No.MB399)1-23
3.2.7 Removing the feed motor
(See Figs.10 to 12)
• Remove the traverse mechanism assembly.
(1) From the top side of the traverse mechanism assembly, re-
move the screw
G
attaching the plate and thrust spring.
(See Fig.10.)
(2) Remove the engagement section
p
attaching the plate to
the feed holder and remove the plate. (See Fig.10.)
(3) Remove the engagement sections (
q
,
r
), remove the thrust
spring. (See Fig.10.)
(4) Remove the wires from the soldered section
s
on the spin-
dle motor board. (See Fig.11.)
Reference:
When attaching the feed motor, pass the wire through
the section
t
on the spindle base. (See Fig.11.)
(5) Remove the feed holder, feed motor, lead screw, feed gear
E and feed gear M at the same time after removing the
three screws
H
attaching the feed holder. (See Fig.11.)
(6) From the side of the feed holder, remove the two screws
J
attaching the feed motor. (See Fig.12.)
3.2.8 Removing the spindle motor board
(See Figs.11 and 13)
• Remove the traverse mechanism assembly and DVD module
board.
(1) From the top side of the traverse mechanism assembly, re-
move the wires from the soldered section
s
on the spindle
motor board. (See Fig.11.)
(2) From the bottom side of the traverse mechanism assem-
bly, remove the three screws
K
attaching the spindle motor
board. (See Fig.13.)
Fig.10
Fig.11
Fig.12
Fig.13
Thrust spring
Plate
G
p
Traverse mechanism assembly
q
r
Thrust spring
Feed holder
Spindle motor board
Spindle base
Feed holder
Feed gear E
Feed gear M
Feed motor
Lead screw
Wires
t
H
H
s
Feed holder
J
Traverse mechanism assembly
K
