Justgo.uk.com
Fitting Snow Chains
Fitting your snow chains
1
Unfold chain with red plastic end of cable towards
the left.
2
Pass flexible cable around back of tyre, from left to
right.
3
Pull the flexible cable up around the back of the tyre
and fasten the steel ends together. Pull the chains
around the front of the tyre.
4
Hook the outside flat green connector to the last link
of the red end chain.
5
Pass the red chain into the red self-locking slide gear
then hook on to the opposite side (if not possible
fasten to another link).
6
After initial fitting drive a few metres, stop and
check the snow chains for correct adjustment and
positioning, incase it is necessary to re-adjust, tighten
or improve upon the positioning.
Snow chains are for emergency use only; to get you out of trouble or danger. They are not designed for prolonged use
and you should not exceed 30mph/50kmh
Always install the chains on the front wheels
1
2
3
4
5
6
Removing
1
Unhook the red elastic tensioner and bring back
through the slide gear.
2
Unfasten the cable at the red point..
3
Roll forward slightly to release the chain underneath
the tyre.
18
