Chapter 4—Configuring Network
Fusion Catalyst 4000 Getting Started Guide
19
4. Configuring Network
This section describes the various steps needed to configure the network
and connections in your Fusion Catalyst System. These steps usually only
have to be performed one time when the system is installed.
4.1 First Time Startup
Note
It is recommended that you have a standard multi-sync
monitor (or flat panel) available for configuring your Wall
Controller for the first time. Your Wall Controller has been
configured at the factory for a single display and a
resolution of 1024x768 at 60 Hz refresh rate.
Power-on the Fusion Catalyst and wait for Windows to boot. The factory
has already entered the Windows Product ID; however, you will be
required to answer a few other questions for Windows. Note that you can
find your Product ID on the side of the chassis. You will need this Product
ID in order to complete the Windows installation if you re-install.