JUNO JDK5575E, Instruction Booklet

Page: 9 / 14

18
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
GB
• When ducting the hood through the side air outlet from
the lower chimney element I it is necessary to insert
deflector D into spigot R to close off the opening that is
not being used ( fig.6 ).
• Cut the additional spigot P in correspondence with outlets
1 and 2 , which must be formed directly on the piece.
Connect the additional spigot
P to the round fan outlet,
pushing it downwards, and fit spigot R to additional spigot
P in a similar manner (make sure that the two additional
side recirculation spigots P1 are fitted to spigot R ). Make
sure that the height of the assembly R + P corresponds
to the height of the chimney outlet ( fig. 7 ).
• If the hood is supplied with the activated charcoal filters
fitted, the filters should be removed (see paragraph on
Maintenance ).
• Recirculation fitting
• The filtered air is returned to the room through the two
plastic side grills G on the lower chimney element I .
• Connect the additional spigot P to the round fan outlet,
pushing it downwards, and fit spigot R to additional spigot
P in a similar manner (make sure that the two additional
side recirculation spigots P1 are fitted to
spigot R ). Cut the additional spigot P in
correspondence with outlets 1 and 2 , which
must be formed directly on the piece. Make
sure that the height of the assembly
R + P
corresponds to the height of the chimney
outlet.(
fig.7 ).
• Fit the activated charcoal filters inside the
canopy (see paragraph on Maintenance ).
Do not fit the venting grilles until after the
chimney has been installed.
Fig. 6
Fig. 7
D
R
P1 P1
P
D
R
P1 P1
P
R
P1 P1
P
G
R
P1 P1
P
G