JUNO JDK5575E, Instruction Booklet

Page: 13 / 14

22
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
GB
Active carbon filter
• Operation
The activated charcoal filter is only fitted in
recirculation type hoods. It will retain odours until
it becomes saturated. It cannot be washed or
regenerated, and must be replaced when the
Filters LED starts, or at least once every 4 months
of use. This indicates that as well as replacing the
activated charcoal filter, it is also necessary to
perform maintenance operations on the metal
grease filters.
• Replacing
Remove the grease filters and take out the
activated charcoal filter from its housing, turning
the lugs provided
(fig. 12) . Insert the new activated
charcoal filter and replace the metal grease filters.
• Enabling the alarm signal
In recirculation type hoods the saturated filters
alarm must be enabled as indicated below:
- Turn off the lights and the suction motor;
- Press and hold the
T4 button for at least 10
seconds, until the LEDs start to flash. Note the
number of flashes:
- 2 flashes of the LED Activated charcoal filter
saturation alarm
ENABLED .
- 1 flash of the LED Activated charcoal filter
saturation alarm
DISABLED ;
• Resetting the alarm signal
To turn the alarm signal off, proceed as follows:
- Press the T4 button for at least 3 seconds, until
the LEDs flash in confirmation. In any case the
saturated filters alarm will only come into operation
when the suction motor is turned on.
WARNING: always comply with the
maintenance and replacement times indicated,
in order to avoid a possible risk of fire when
the filters are saturated with grease.
Fig. 12