Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x35mm)
Screw (2x10mm)
3mm
9mm
2mm
Assemble the rudder servo in the fuselage.
The sketh amp of the steel wires in the fuselage
Epoxy two board together and trim a slot to appropriate
position in the boards.
Install the servo to the board.
Install the metal rod control horm and connect the linkage.
Drill a hole to appropriate position in the rudder and
assemble the metal rod horn to it.
51
52
53
54
55
10
50
TP Screw (3x20mm)
Landing gear
1
4
TP Screw (3x20mm)
Landing gear straps 2
2mm
6mm
16
TP Screw (3x14mm)
Landing gear straps
8
2
4
2
Collar (6mm)
Wheel (115mm)
PVC part
2
Wood dowel (6x50mm)
2
2
Blind Nut (6mm)
Screw (6x50mm)
2
Wheel pants
Landing gear
1
Ply (15x15x3mm)
8
Mount landing gear on the underside of wing.
Cut off the surplus part of
Wheel pants
.
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x35mm)
Retainer
3mm
18
Pin hinge
16mm
Assemble the pin hinge to the wings ,the flaps & the
ailerons.Adjust them to the perfect position.
Epoxy the pin hinge steadily in the wings,the flaps and
the ailerons.
Assemble the arms in the flaps and aileron and connect
the servo arms to them with rods as below.
Be care the pin hinges should
be in line in each plane.
Make sure the hinges
can move smoothly.
12
13
14
15
11
3
Accessory list for the coming installation steps.
