Pin hinge
3
Make sure hinges are
mounted in the same line.
80mm
66mm
35mm
40mm
4mm
1
Rib template (3mm ply)
4mm
4
Wood dowel (4x30mm)
1
Stab joiner (10x230mm)
According to the rib template drill holes
in the stabilizer and fuselage!
1
U-style wire (3mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
2x7mm
2x7mm
2.5mm
Epoxy pin hinges to rudder.
Epoxy the horizontal tail to fuselage.Remove paint
at fuselage horizontal mating surfaces before epoxy.
Drill two holes at the stabilizer root base on rib template
and epexy the metal dowel in them.
A ccording to thr rib template drill holes to the tail of
fuselage as below.
Set the U-style wire through the tail of fuselage as
below.
Glue the elevator to the stabilizer by CA and epoxy.
28
29
30
31
32
6
27
C = C '
D = D '
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
C
D
C'
D'
1mm
Rudder
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Tail gear supporter
Tail landing gear
Note:rudder wheel in optional.
Collar
Collar
TP Screw ( 3x20mm)
1.5mm
Ply (30x20x9mm)
4
TP Screw (3x20mm)
Ply (30x20x9mm)
1
2.5mm
Drill hols to appropriate position in the vertical tail
and epoxy the rudder to the vertical tail steadily.
Assemble horizontal tail, vertical tail,
tail gear separately.
Epoxy the fibre glass tubes to appropriate
position as below.
Assemble the tail wheel as below.
Epoxy the tail landing gear to the rudder.
Fix the tail gear supporter to fuselage.
34
33
35
37
7
38
36
