Juniper LN1000 - RELEASE NOTES 8-27-2010, User Manual

Page: 38 / 64

Installing the LN1000 Router
Figure 7: LN1000 Mobile Secure Router — Front Panel
g017375
RJ-45 Connector for debug Ejector latch Wedge lock Status LED Wedge lock
Guide rail Guide rail
To install the LN1000 router in a VITA 46.0–compliant chassis:
1.
Insert the router into the guide rails located on the front of the chassis.
2.
Slide the router forward until the connector on the router’s back panel contacts the
connector in the chassis.
3.
Push in the injector/ejector latch on the right side of the router front panel to complete
the installation. If your chassis is not equipped to utilize the injector/ejector latch to
assist in insertion, press the front surface of the LN1000 router until its connector is
fully seated in the chassis.
4.
Using the 3/32 Allen wrench, tighten the two wedge locks to a torque of 7 in-lb.
CAUTION: The guide rails provide cooling to the conduction-cooled router.
If you do not properly tighten the wedge locks, the router can overheat
and fail.
Related
Documentation
Before You Install the LN1000 Router on page 23
•
•
Powering On the LN1000 Mobile Secure Router on page 25
•
Unpacking the LN1000 Router on page 21
Removing the LN1000 Mobile Secure Router
The LN1000 router is hot-swappable; power can be left on while you remove or replace
a router module without damage to the router or backplane.
24
LN1000 Mobile Secure Router