Juniper LN1000 - RELEASE NOTES 8-27-2010, User Manual

Page: 40 / 64

0:00:00.0 0x003b1304
PCIe port 0 had 1 busses
HWA FPGA Version 0x0004090900000013
PCIe: Waiting for port 1 link
PCIe: Port 1 link active, 4 lanes
Probing PCIe port 1
1:00:00.0 0x0009184e
PCIe port 1 had 1 busses
IDP Revision Date-Time: 05/28/08-18:00:00
Enumeration took 0 reboots
Juniper LN1000-V revision 2.0, Serial# ************
Juniper Part # 710-027379 Bootstrap version 10.0I
Build: 10.0B3.7 #0: 2009-09-25 16:36:56 UTC
builder@ormonth.juniper.net
SDRAM: 1024 MB
Boot flash: 16 MB @ 0x1fc00000
IDE flash: 977.4 MB (2001888 x 512)
USB: 1.8 GB (3911616 x 512)
current_dev: ide
coremask: 0xfff (12 cores)
resetmask: 0xffe (1 cores running)
reset: Hard
NVMRO: Write-enabled
watchdog: Armed
FPGA: Enabled
Hit any key to stop autoboot: 10
IPMC test
IPMC test completed, 1 pass, 0 errors, 0 warnings
BOOT >
For normal operation, allow the autoboot to proceed. Full POST diagnostics then run,
and the system starts Junos OS normally. If detailed diagnostics must be run, or if alternate
media (for example, a USB storage device) must be booted, press ENTER during the
10-second count-down. The following bootstrap prompt is displayed:
BOOT>
If POST diagnostics or the bootstrap sequence fails, this prompt is redisplayed, and the
front panel LED lights red.
You are now ready to configure and operate the router.
Related
Documentation
•
LN1000 Router Power Requirements on page 13
•
SPOST and POST Diagnostic Tests on page 35
•
LN1000 Rear Transition Module Front Panel Status LEDs on page 43
26
LN1000 Mobile Secure Router