Known Problems and Limitations
53
Release 10.3.2
When any of the subsystems is excluded for a JunosE release, a unified ISSU to
that release fails to apply conversion code to all of the line modules. As a result,
the line modules reset when they come up with that release. [Defect ID
179595]
Work-around:
To prevent the exclusion of a subsystem file from the release, do
the following before you upgrade to a new JunosE release that supports unified
ISSU:
1.
Issue the
show subsystems file
fileName
.rel
command, where
fileName
is
the name of the software release file, to determine whether any of the
subsystem files are excluded from the release.
2.
For each subsystem file that is excluded, issue the
no exclude-subsystem
subsystemName
command to remove the exclusion for the specified
subsystem file.
If you copied the software release to the router before removing the subsystem
file from the exclusion list, you must copy the release to the router again to
ensure that all subsystem files are included in the release.
During the unified ISSU operation, if you modify the router configuration after
the initialization phase of the process is completed and before you issue the
issu start
command to commence the upgrade phase of the unified ISSU
process, the unified ISSU procedure completes successfully and the stateful SRP
switchover process begins to synchronize between the active and standby SRP
modules. When the synchronization process is in progress, the standby SRP
module reloads for the second time. After the second reload of the standby SRP
module ends, the synchronization process also ends properly.
Although the standby SRP module reloads for the second time when it is
synchronized with the upgraded release, normal router operations, such as
handling of subscriber sessions and forwarding of traffic, remain unaffected.
[Defect ID 185517]
