Known Behavior
33
Release 10.3.2
When IP tunnels are configured on a router enabled for stateful SRP switchover,
and the Service Module (SM) carrying these tunnels is reloaded, stateful SRP
switchover transitions to the pending state. Stateful SRP switchover remains in
the pending state for 10 minutes following the successful reloading of the SM.
This amount of time allows for IP tunnel relocation and for the tunnels to
become operational again on the SM. If an SRP switchover occurs while in the
pending state, the router performs a cold restart.
Work-around:
None.
Subscriber Interfaces
MAC address validation is not supported on either of the following:
Packet-triggered subscriber interfaces that are created dynamically
Packet-triggered subscriber interfaces that are managed on the primary IP
interface
A packet-triggered subscriber interface is created when the router receives a
packet with an IP source address that does not match any entries in the
demultiplexer table. When the router detects an unmatched packet, it generates
a trigger event that determines whether to create a dynamic subscriber
interface or configure an existing interface. To configure packet detection on
the router, use the
ip auto-detect ip-subscriber
command.
System
ERX routers display different behavior from E120 routers and E320 routers
when reporting modules as inactive.
ERX routers report a module as inactive when either:
The I/O module is not present
The primary line module is fully booted and ready to resume operation. In
this case, the standby is currently providing services.
E120 routers and E320 routers report a module as inactive when either:
The primary line module has no IOAs.
The primary line module has IOAs, but they have failed diagnostics.
The standby line module has taken over for the primary line module, and
has control of the IOAs.
Because E120 and E320 routers can accommodate up to two IOAs per slot, at
least one IOA must be online. If the second IOA fails, the line module is still
online, but does not use both IOAs. You can ensure that every module is up and
active in the system and not in a failed state by issuing the
show version all
command.
