Juniper Junos Space JA1500, Hardware Manual

Page: 105 / 210

•
To modify the virtual IP (VIP) address, type
1
and follow the prompts on the CLI.
NOTE: For nodes in a Junos Space fabric, you can modify a VIP address
from any node in the fabric.
•
To modify the settings of the Ethernet interface eth0, type
2
and follow the prompts
on the CLI.
You can change the IP address of the node, the subnet mask, and the default
gateway.
• To modify the settings of the Ethernet interface eth3, type 3 and follow the prompts
on the CLI.
You can change the IP address of the node, the subnet mask, and the default
gateway.
NOTE:
•
The Change Device Management Interface option is available only if
a device management interface (eth3) was specified during the initial
configuration of the appliance.
• When you configure the eth3 interface as the device management
interface, the IP addresses of the eth0 and eth3 Ethernet interfaces
must be in different subnets.
•
To modify the NAT configuration, type
4
or
1
, depending on the menu options
displayed, and follow the prompts on the CLI.
NOTE:
•
The NAT configuration must not be modified in combination with the
other changes that require a reboot of the node. If the node is rebooted,
the NAT configuration is discarded. In such cases, modify the settings
that require a reboot, reboot the node and then modify the NAT
configuration.
•
If you modify only the NAT IPv4 or IPv6 address of a virtual appliance
configured to be part of a Junos Space cluster, but yet to be added to
the cluster from the Junos Space Platform UI, the last specified IP
address overwrites the IP address configured during initial
configuration. For example, if the virtual appliance was initially
configured with a NAT IPv4 address and while modifying the network
settings, you specify an IPv6 address, then the IPv4 address is
discarded and the IPv6 address is used for the NAT gateway. If both
IPv4 and IPv6 are configured initially, then only the IP address that is
modified is updated.
91 Copyright © 2018, Juniper Networks, Inc.
Chapter 7: Performing Initial Configuration