+
-
L
N
INPUT
AC - LINE
AC - NEUTRAL
OUTPUT
REMOTE
LED
DRIVER
Low voltage wires
from LED driver
White lead (+)
from fixture
+ 24VDC lead from
remote driver
- 24VDC lead
from remote
driver
Silver Shielding
(-) from fixture
Set screw
Set screw
Set screw
Canopy
1/8IPS nut
Top cap
Cover plate
FIGURE 9
Set screw
Bottom cap
Power cord
from fixture
Canopy
Cap screw
Set screw
FIGURE 10
Wires from
remote
driver
Wood screw
Washer
2
STEP 1B: CEILING MOUNTING INSTALLATION INSTRUCTIONS
5
6
3
Pass low voltage wires from the remote
driver through the smaller hole in the
top cap. Using provided wood screw
and washer, connect the top cap to
ceiling. Wood screws are provided for
default installation. Alternate screws
may be used at the recommendation
of an electrician.
Loosen cap screw in bottom cap to release the
bottom cap. Pass power cord from fixture through
the cap and canopy as shown. Adjust the length of
power cord to adjust fixture's drop height. Tighten
set screw after adjusting power cord length. Attach
bottom cap by tightening the cap screw.
Make sure bottom cap and canopy are aligned
properly before securing cap screw.
Connect wires according to diagram (wire nuts provided).
Wires to and from the driver are not included.
FIGURE 7
Push wires inside the canopy and use set screws (removed
in first instruction) to connect canopy to cover plate.
FIGURE 8
Remove set screws from canopy to
release the top cap.
1
FIGURE 11
FLUTES LYDIAN PENDANT INSTALLATION GUIDE
3
WWW.JUNIPER-DESIGN.COM | [email protected] | +1 347 799-2915 | 157 WATER STREET SOUTHINGTON, CT 06489
