Jungheinrich EJD K18, Operating Instructions Manual

Page: 29 / 81

0205
.GB
D 6
– Remove the connector (8) from the socket and store the mains cable back under
the battery panel.
Z
Charging continues automatically after a mains failure.
Charging can be interrupted by removing the mains connector and continued as
partial charging.
F
The mains cable must not be opened.
Before starting the truck, the battery panel must be firmly closed.
Charging times
The duration of charge depends on the battery capacity.
LED display
Compensation charge
Compensation charge starts automatically when charging is complete.
Partial charging
The charger is designed to automatically adapt to partially charged batteries. This
keeps battery wear to a minimum.
Green LED
(charge status)
Red LED
(fault)
Display
Lit --- Charging complete, battery full. (Charging interval,
compensation charge)
Flashes slowly --- Charging
Rapid flash --- Display at beginning of charge or after setting a new
characteristic curve. Number of flash pulses
corresponds to the characteristic curve set.
--- Lit Overtemperature. Charging is interrupted.
--- Flashes slowly Safety charging time exceeded. Charging is
cancelled. Mains must be disconnected for charging
to recommence.
--- Rapid flash Invalid characteristic curve setting.
--- --- Mains failure and/or no battery connected.
0205
.GB
D 6
– Remove the connector (8) from the socket and store the mains cable back under
the battery panel.
Z
Charging continues automatically after a mains failure.
Charging can be interrupted by removing the mains connector and continued as
partial charging.
F
The mains cable must not be opened.
Before starting the truck, the battery panel must be firmly closed.
Charging times
The duration of charge depends on the battery capacity.
LED display
Compensation charge
Compensation charge starts automatically when charging is complete.
Partial charging
The charger is designed to automatically adapt to partially charged batteries. This
keeps battery wear to a minimum.
Green LED
(charge status)
Red LED
(fault)
Display
Lit --- Charging complete, battery full. (Charging interval,
compensation charge)
Flashes slowly --- Charging
Rapid flash --- Display at beginning of charge or after setting a new
characteristic curve. Number of flash pulses
corresponds to the characteristic curve set.
--- Lit Overtemperature. Charging is interrupted.
--- Flashes slowly Safety charging time exceeded. Charging is
cancelled. Mains must be disconnected for charging
to recommence.
--- Rapid flash Invalid characteristic curve setting.
--- --- Mains failure and/or no battery connected.