Jungheinrich EJC 212-220, Operating Instructions Manual

Page: 66 / 93

F 5
0307
.GB
Maintenance intervals
Standard =
t
W A B C
Cold store=
k
Hydraulic
operation 7.1 Check mast bearings
t
7.2 Check setting of slide pieces and stops, and adjust if
necessary
t
7.3 Visually inspect the mast rollers and check contact
surface wear level
k t
7.4 Check lateral clearance of mast connections and of fork
carriage
t
7.5 Check load chain setting and tighten if necessary
t
7.6 Check forks and fork carriage for wear and damage
k t
7.7 Check mast tilt angle
t
7.8 Test hydraulic system operation
k t
7.9 Check that hose and pipe lines and their connections
are secure, check for leaks and damage, and tighten
connections if necessary.
k t
7.10 Check cylinders and piston rods for damage and leaks,
and make sure they are secure
k t
7.11 Check the hydraulic oil level
k t
7.12 Replace hydraulic oil (this may have to be performed
using a special environmental service truck)
t t
7.13 Replace the hydraulic oil filter
t
7.14 Test tie rods (EJC-Z only)
t
Agreed
performance
levels 8.1 Lubricate truck in accordance with Lubrication
Schedule.
k t
8.2 Test run
t
8.3 Demonstration after servicing
k t
Steering
system 9.1 Test electric steering
t
9.2 Test steering play and steering chain
t
Fitting times 10.1 Enable servicing and inspection by removing/
assembling panels and covers.
F 5
0307
.GB
Maintenance intervals
Standard =
t
W A B C
Cold store=
k
Hydraulic
operation 7.1 Check mast bearings
t
7.2 Check setting of slide pieces and stops, and adjust if
necessary
t
7.3 Visually inspect the mast rollers and check contact
surface wear level
k t
7.4 Check lateral clearance of mast connections and of fork
carriage
t
7.5 Check load chain setting and tighten if necessary
t
7.6 Check forks and fork carriage for wear and damage
k t
7.7 Check mast tilt angle
t
7.8 Test hydraulic system operation
k t
7.9 Check that hose and pipe lines and their connections
are secure, check for leaks and damage, and tighten
connections if necessary.
k t
7.10 Check cylinders and piston rods for damage and leaks,
and make sure they are secure
k t
7.11 Check the hydraulic oil level
k t
7.12 Replace hydraulic oil (this may have to be performed
using a special environmental service truck)
t t
7.13 Replace the hydraulic oil filter
t
7.14 Test tie rods (EJC-Z only)
t
Agreed
performance
levels 8.1 Lubricate truck in accordance with Lubrication
Schedule.
k t
8.2 Test run
t
8.3 Demonstration after servicing
k t
Steering
system 9.1 Test electric steering
t
9.2 Test steering play and steering chain
t
Fitting times 10.1 Enable servicing and inspection by removing/
assembling panels and covers.