099
9.G
B
E 10
Emergency lowering system
f
The emergency lowering system may only be used if there are no persons within the
danger zone.
If the lifting device can no longer be lowered due to a defect in the lifting control sy-
stem, the emergency lowering system has to be activated.
– Set key switch (2) to its "0" position
and set the master switch (1) to its
"OFF" position.
– Pull the battery connector (see chap-
ter D).
– Open the front hood (see chapter F).
– Loosen the screw on the valve group
(13).
A
The required Allen key (2.5 mm) can be
found at the valve group.
The lifting device is lowered.
– Retighten the screw (13) after the
emergency lowering procedure has been performed.
f
The truck may only be retaken into service after the required troubleshooting measu-
res were successfully performed.
4.4
Safe parking of the truck
If the truck is left unattended, even for only short periods of time, it must be rendered
safe.
f
Do not park the truck on slopes! The lifting device must always be completely lowe-
red.
– Bring control shaft (4) into brake position (B).
– Lowering the lifting device.
– Set key switch (2) to "0" position and remove the key.
– Set master switch (1) to "OFF" position.
13
099
9.G
B
E 10
Emergency lowering system
f
The emergency lowering system may only be used if there are no persons within the
danger zone.
If the lifting device can no longer be lowered due to a defect in the lifting control sy-
stem, the emergency lowering system has to be activated.
– Set key switch (2) to its "0" position
and set the master switch (1) to its
"OFF" position.
– Pull the battery connector (see chap-
ter D).
– Open the front hood (see chapter F).
– Loosen the screw on the valve group
(13).
A
The required Allen key (2.5 mm) can be
found at the valve group.
The lifting device is lowered.
– Retighten the screw (13) after the
emergency lowering procedure has been performed.
f
The truck may only be retaken into service after the required troubleshooting measu-
res were successfully performed.
4.4
Safe parking of the truck
If the truck is left unattended, even for only short periods of time, it must be rendered
safe.
f
Do not park the truck on slopes! The lifting device must always be completely lowe-
red.
– Bring control shaft (4) into brake position (B).
– Lowering the lifting device.
– Set key switch (2) to "0" position and remove the key.
– Set master switch (1) to "OFF" position.
13
Summary of Contents for EJB 14
