X*AP RM
1
2
Introduction
At the heart of the
X*AP RM
1
works a high power 32bit embedded micro controller.
It runs a web server to initiate firmware updates.
The communication protocol is EmBER+. So any device that speaks this protocol may easily be controlled by
the
X*AP RM
1
.
The
X*AP RM
1
remote panel functions are for now limited to operating needs rather than setting up a device.
Beside the pre-configured key functions like loudness measurement or speaker control, the 8 Hot-Keys may
be programmed by the administrator as part of the
D*AP
events system.
Hardware concept
The
X*AP RM
1
remote panel is a stand alone unit. In the past it was possible to mount it in front of some
1RU devices but this is no longer the case.
The
X*AP RM
1
remote panel
is powered by an external 5V wall power supply. The
X*AP
RM
1
comes with a
cord grip. One can insert one or two plastic snap-in posts and secure the cable:
Important Note!
There are older versions of the
X*AP RM
1
around which don't have a 5V input.
These models must be powered via POE (power over Ethernet) either from a switch that has POE ports
or from a POE wall power supply.
