junger T-AP, Manual, Page: 42 / 68

T*AP
38
Surround Balance
[0.0 … 1.0]
defines the amount of direct sound mixed into the surround channels.
0.0 provides pure ambient sound while 0.1 to 1.0 will increase the
amount of direct sound.
Surround Gain (dB) [0 … -24.0]
sets the level of Ls/Rs channels.
LFE [ON / OFF]
you may turn this option on if the upmix process must generate a
subwoofer signal that will appear in the LFE channel.
LFE Gain (dB) [-20.0 … 20.0]
you can set the LFE level here
setup GUI – AUDIO PROCESSOR – Fail Over (4 x 2 program configuration)
For the 4x2 Program Configuration (SYSTEM > T*AP Program Configuration) the T*AP offers
four independent Fail Over circuits (see Overview sketch on page 34).
The source for the Fail Over circuit can be either the adjacent program input (e.g. input 2L/R for the
program input 1L/1R) or the AUX input. The Mode switch will select the respective signal path.
See the example above for the four program outputs :
program 1 (1L/1R) has a valid input signal and is prepared for auto switch over
to the second program input 2L/2R.
program 2 (2L/2R) has no valid input and has automatically switched over
to the AUX input.
program 3 (3L/3R) has a valid input and is prepared for auto switch over
to input 4L/4R, input 4L/4R has valid input.
This is indicated by the yellow soft LED.