junger T-AP, Manual, Page: 15 / 68

T*AP
11
getting started – IP setup of the Base Unit
–
via web browser
* Read the default IP address printed on a label above the RJ45 Ethernet connector.
* Set up network parameters of the PC which meet the default IP address of the Base Unit
(net mask = 255.255.0.0).
* Connect the Base Unit with the PC either by an Ethernet cross over cable or by a switch.
* Open a browser and type IP address of the Base Unit into the URL field and press <ENTER>.
This will open the AUDIO PROCESSOR tab sheet of the GUI.
* Click on <SYSTEM> and the "Admin" tab will open automatically :
Enter the desired network configuration and press <apply>
Afterwards you must reboot the Base Unit in order to activate the new IP configuration.
Regarding Gateway address see above.
Important Note! After reboot neither the web browser nor the X*AP Remote Panel may be able to
communicate with the Base Unit. You must key in the new IP address in the URL field and change
the X*AP Remote Panel settings to attach this device again.