Jünger Audio-Studiotechnik GmbH
page
27
Sources
Setup
MICs
pane :
Each of the two
MICrophone
inputs can be selected to be at
Input-Mode:
MIC Level (with then 2 options for the
Preamp
gain (LOW or HIGH s. level diagram)
LINE Level.
Phantom:
power may also be set on or off for each MIC input.
Labels
can also be entered for these inputs – they will be displayed on the Remote’s surface as
discussed above.
Offset Gain:
adjustment may be set in 1 dB steps.
Disabled:
when checked this input is
not available
for source selection. This is important if you are
using this particular input for Monitoring purposes only. See Monitor Setup.
When these Mic inputs are assigned to Strips, the
Faders
on those Strips may be configured to
operate
Tally
controls such as machine
“Start:”
,
“ON AIR:”
lights, etc. The
“Value:”
field determines
how far up the fader will be to operate the
Start
and/or
On Air
event control.
Channel Button:
selections determine the action of these buttons on Strips where either
MIC inputs is assigned.
PFL / MUTE / START / HYBRID
DIGITAL
pane:
There are 4 pairs of
AES Digital Inputs
to the MIX4 on the main board.
Setting options are similar to MIC inputs above with the exception of the
Router
check boxes
Format
drop down boxes and:
St.
: will put the channel strip for that particular source into stereo mode.
M./S.
: will activate a matrix that converts M/S stereo sources into X/Y (or A/B you name it)
2Ch. :
will make this input permanently available as a 2 channel source (that is,
not
as a stereo pair).
This function is also referred to as
Force 2CH
.
Interface 1 / 2
pane:
There are 2 times another 4 pairs of inputs, each for the
interfaces
installed (only available if installed).
Setting options are similar to Digital pane above.