Jünger Audio-Studiotechnik GmbH
page
21
<USER> Operator Management
An
administrative
person manages the Mix 4 with the help of the
Setup software
. He or she sets the
device-relevant parameters like source names, offset gains, GPI/Tally functions etc., as well as Operator
names and their
PIN
numbers.
In principle the MIX4 knows
10 Operators
and one
Guest
. After turning power on the device is in
Guest
mode. If one is a registered Operator one can log in to the MIX4 and will then be forced to authorized himself
by a four digit
PIN-number
.
When pressing the
<USER>
button the following display appears :
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
S e l e c t
P r s t L o a d S n p L o a d S n p S t o r e
O p r t r 1
P R E S T 1 S N A P 1 S N A P 1
“Select”
indicates that you are is in the
Guest area
and able to select one of the 10 Operators.
Turn the
A
knob to do so .
The selection is confirmed by pressing Channel Rotary Knob
A
.
Next you will be asked to enter your pin number, as shown across the displays:
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
O p
r t r 1
E
n t e r y o u r P
i n
0
0
0 0
Turn each Channel Rotary Knob in turn to enter the 4 digits of your
PIN
.
Then press any of the Rotary Knobs to confirm the entry.
If the
PIN
is correct the data of that Operator will be loaded and the display will turn back to mix mode.
Pressing
<USER>
again will then show this:
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
O p r t r 1
P r s t L o A d S n p L o a d S n p S T o r e
L o g O u t
P R E S T 1 S N A P 1 S N A P 1
(The Operator can log out here by pressing Channel Rotary Knob
A.
You don’t want to do that now, of
course!
Important note!
If you want to save latest settings which are not included in a Snap Shot, be sure to log out.
This will store the actual Operator data to NV memory.