4. OPERATION
The Ø-REV function turns the phase of the input signals around
180°. Repeated pushing the REV button switches the following
modes:
Ø-REV CH 1
(or CH3)
Ø-REV CH 2
(or CH4)
Ø-REV CH 1+2
(or CH3+4)
Red LED’s gives information about Ø-REV status.
Adjustments for MONO and Ø-REV will be stored into the
presets.
INPUT GAIN means linear amplification of input signals. The
input gain can be changed in steps of 0.1 dB , within a range
from -15...+15 dB.
Adjustment of GAIN is channel independent. GAIN adjustment is
stored into the presets.
GAIN
selection of channel
GAIN
adjustment of gain for selected channel
The matrix is to configure with the INPUT buttons and the
OUTPUT buttons.
1. selection of input channel by pushing related INPUT button
2.
selection of requested output channel by pushing related
OUTPUT button.
This procedure is to repeat up to all necessary connection are
routed.
The configuration of the matrix is stored into the presets.
After mixing together several input channels output level will be
increased. If excessive level at the output occurs one has to
reduce output level by reducing the OUTPUT GAIN (see also
4.8 Monitor). The output gain can be changed in steps of 0.1 dB
, within a range from -15...+15 dB.
Adjustment of GAIN is channel independent. OUTPUT GAIN
adjustment is stored into the presets.
4.4
Ø-REV
4.5
INPUT GAIN
push
turn
4.6
MATRIX
4.7
OUTPUT GAIN
GAIN
selection of channel
GAIN
adjustment of gain for selected channel
push
turn
operation manual b40, chapter 4 -Operation- page 4-3