3. INSTALLATION
INSTALLATION 3
UNPACK
THE
UNIT
3.1
The digital dynamics processor ACCENT2 was
carefully packed in the factory and the
packaging was designed to protect the
equipment from rough handling.
Please examine carefully the packaging and its
contents for any signs of physical damage,
which may have occured in transit.
POWER
SUPPLY
3.2
The digital dynamics processor ACCENT2 is a
device under the safety category
Schutzklasse1 in keeping with the VDE 0804
standards and may only used with power
supply installations built according to
regulations.
Check the voltage details printed at the rear
panel are the same as your local mains
electricity supply.
CONNECTIONS
3.3
The digital dynamics processor ACCENT2 is
equipped with standard connectors (see also
chapter 4).
Before connecting the digital dynamics
processor ACCENT2 switch the power off at all
connected units.
RACK
MOUNTING
3.4
The digital dynamics processor ACCENT2 is
made as standard 19“ unit (EIA format). It
occupies 1 RU (44 mm height) space in a rack.
Please allow at least addititonal 3“ depth for
the connectors on the rear panel.
When installing the unit in a 19“ rack the rear
side of the unit needs some support, especially
for mounting in flight cases.
OPERATION SAFETY
3.5
The digital dynamics processor ACCENT2
should not be installed near units which
produce strong magnetic fields or extreme
heat. Do not install the filter processor directly
above or below power amplifiers.
If, during operation, the sound is interrupted or
displays no longer illuminate, or if abnormal odor
or smoke is detected immediately disconnect
the power cord plug and contact your dealer or
Jünger Audio.
operation manual accent2 chapter 3 -Installation- page 3-1