9
Install faceplate
•
Put the wires through the cable entry of the
faceplate.
•
Fasten the device with the delivered screws (1)
and (2) into the installation frame.
•
Put the bell button covers onto the plug-in position
as required. Observe the top and bottom edge of
the cover.
!
Do not pinch the wires.
First tighten the upper screw (1) after this
the lower screw (2).
Connect the wires
•
Take off the connection block downwards.
•
Attach the wires to the connection block in
accordance with the terminal description.
•
Plug on the connection block.
•
Place the wires into the space under the
connection block.
Protruding wires disturb the
installation of the inscription plate.
Terminal description
Carry out the following steps before closing the device:
•
commissioning
•
cover configuration
•
programming
•
adjusting parameter
•
labelling the inscription plate
1
2
