The blind/shutter starts.
The status LED flashes after 4 seconds and the blind/shutter stops. The actuator is in
programming mode for approx. 1 minute.
o
Switch radio transmitter to programming mode (see radio transmitter instructions).
o
Trigger telegram on the radio transmitter.
The status LED lights up for 5 seconds.
The actuator is connected to the radio transmitter. The actuator and radio transmitter exit
the programming mode automatically.
i
If the status LED of the actuator flashes 3 times at 1-second intervals for approx. 5
seconds, then the programming operation was not successful. All the memory locations in
the actuator or radio transmitter are occupied.
i
Scene buttons must be connected separately.
Disconnecting connection to a radio transmitter
o
Carry out the same steps as when connecting (see Connecting actuator to radio
transmitters).
The status LED of the actuator flashes quickly for 5 seconds.
The actuator is disconnected from the radio transmitter. The actuator and radio transmitter
exit the programming mode automatically.
i
If there several connections or scene buttons for a radio transmitter, all connections must
be disconnected individually.
Resetting the device to the factory setting
All connections to radio transmitters are disconnected and parameters are reset to default
setting. If the operating mode switch is on
PC
, the rolling shutter operating mode is set.
i
The connections in the radio transmitters are preserved and must be deleted separately.
Load is switched off.
o
Press the
Prog
button for at least 20 seconds.
The blind/shutter starts.
The status LED flashes after 4 seconds and the blind/shutter stops. The status LED flashes
faster after 20 seconds.
o
Release
Prog
button and press briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The device is reset to default setting.
6 Appendix
6.1 Technical data
Rated voltage
AC 230 V ~
Mains frequency
50 / 60 Hz
Ambient temperature
-25 ... +70 °C
Minimum actuation time in operating mode
Venetian blind
0.1 s
Roller shutter
0.3 s
Minimum switching current AC
100 mA
Contact type
µ
Standby power
max. 0.5 W
Running time
1 ... 600 s
Running time default setting
120 sec
Slat adjusting time
0 ... 10 s
Connected load
Motors
1000 W
Connection
single stranded
0.75 ... 4 mm²
Finely stranded with conductor sleeve
0.75 ... 2.5 mm²
5/11
82581443
J0082581443
24.03.2017
eNet radio blinds actuator 1-gang mini
