12
1.1.3.After the engine starts normally, push the choke to the "on" position, as shown in Fig.5.
(Note: if the machine can not be started again after normal operation and flame out, please check the
power on state of the main power switch.)
Fig.3: Choke closing indication
Fig.4: The ignition switch
Fig.5: Choke opening indication
1.2.Check after start-up:
After the engine is running, it should run at low speed for 3-5 minutes, and then run at high speed
after the machine runs normally. Then check whether the engine operates normally, whether there is
abnormal noise, whether the smoke exhaust is normal, whether the clutch and brake pedal are
normal, whether there is oil leakage or water leakage.
1.3.Check before shutdown:
1.3.1.Put the clutch handle of the spray pump in a separate state.
1.3.2.The boom is folded to the transportation state.
1.4.Shutdown:
1.4.1 Release the accelerator pedal and press the clutch pedal.
1.4.2.Put the shift handle in "neutral" and run the engine at low speed for 3-5 minutes.
1.4.3.Pull up the parking brake to prevent slipping after parking. The parking brake handle is on the
right side of the driver's seat. Pull it up to the parking brake state. Press and hold the front button of
the handle and push down the brake handle to release the brake.
1.4.4.Turn the start key to the "off" position to stop the engine; pull out the start key and turn off the
power.
2.Working and operation:
2.1.Machine running (the operating mechanism of the cab is shown in Fig.6, and the gear shifting
schematic diagram of the gearbox is shown in Fig.7.)
