10
ASSEMBLY
Step 8: Attaching the Foam Sleeve
•
Insert the assembled Upper and Lower Supporting Poles (14, 23) into the wider opening of the Foam Sleeve
(25).
•
Slide the assembled poles in until the top end of the Upper Supporting Pole (23) comes out on the
opposite side.
•
Make sure that the Sleeve (25) covers the entire preinstalled foam of the Supporting Poles.
Smaller opening
Top end of the Upper Supporting Pole
Step 9: Fixing the Ball Cap
•
Place a Ball Cap (2) onto the top end of each Upper Supporting Pole (23). Make sure that the screw
hole on the Ball Cap (2) is aligned with the screw hole on the top end of the Pole.
•
Fasten the Ball Caps (2) using the Ball Cap Screws (3).
Phillips screwdriver
2
3
Step 10: Fixing the Supporting Poles to the Trampoline Legs
•
Place a U-shaped Bolt (18) around one of the Lower Supporting Poles (14).
•
Attach the Spacer (15) to the U-shaped Bolt (18) and then, in an upright position, hold it against one of
the vertical legs of the trampoline.
•
Secure the U-shaped Bolt (18) with a Bolt Clamp (16) and two Locking Nuts (17).
•
Adjust the height level of the Supporting Pole to reach an appropriate position and tighten the
connection with a Spanner (not provided). The bottom end of the Foam Sleeve (25) should be at the
same height level as the Top Rail Frame.
U-shaped Bolt
Lower Supporting Pole
Vertical Leg
Spacer
Bolt Clamp
Locking Nut
Wrench
084-0207-Cantire-8ft Trampoline Combo-GB-02.indd 10
11-11-9 ��4:11
