JUMO TYA S202, Operating Manual, Page: 59 / 99

V1.00/EN/00709725 [Thyristor power controller TYA S202] 59
5 Configuration
5.1.4 Setpoint value configuration
This setting determines which analog input
specifies the setpoint value, how high
the base load is, and which replacement value should be applied in the event of a
fault.
Value / settings Description
Setpoint specifica-
tion Current input This setting specifies which analog input supplies the setpoint
value for the power output.
Note:
These inputs can also be used for logic operation.
v
For switching level, see Chapter 10.7 "Allgemeine
Kenndaten"
Voltage input
Via interface Means that the setpoint value for the power output is provided
via an interface.
Input in the event of
an error Current, voltage, and interface input are monitored for errors
(wire breaks or bus errors). This setting specifies which re-
placement value the power controller should use if the set-
point specification is incorrect.
Last value The last valid value is used by default.
Voltage input or cur-
rent input Depending on which input is set for the setpoint specification,
the second input – which is still free – appears at this point.
If an error (e.g. wire break) now occurs at the current input
which is set by default for the setpoint specification, the power
controller uses the value at the voltage input.
Value, adjustable This means that the "Value in the event of an error" is used.
Value in the event
of an error 000.0 This value is used in the event of an error.
Base load 0...100 %
of output level Note:
This setting is only available if Power controller
r
Thyristor
control
r
Continuous (power controller) is selected.
k
/ bold = default setting
Control signal
P
Base load: 680 W
Maximum
Output level: 3680 W
0 mA
20 mA
3000W 0...20mA
Ⳏ
Base load