JUMO LOGOSCREEN 500, Operating Instructions Manual

Page: 42 / 100

3 Operation and visualization
40
Status
messages Status messages of the disk manager are displayed in the corresponding ac-
tion window. The following status messages are possible:
Status message Description
DISKETTE UPDATED Directly before removing the diskette from the
instrument, it is necessary to call up
Update
diskette, so that all the measurement data up to
the time of removal are contained on the diskette.
The data not yet saved since the last automatic
save are written to diskette.
DISKETTE NOT UPDATED An error has occurred during updating.
This message may have several causes.
Remedy:
Repeat procedure
INITIALIZING DISKETTE The instrument recognizes when new or foreign
diskettes are inserted.
A
New or foreign diskettes are
overwritten
without a security check.
NO DISKETTE If there is no diskette in the instrument, the
diskette symbol flashes in the status line.
DISKETTE
WRITEPROTECTED The inserted diskette cannot be written to
because it is write protected.
Remedy:
Remove write protection.
DISKETTE FAULTY An error has occured while writing to diskette.
The diskette is faulty.
Remedy:
Insert new (DOS-formatted) diskette.
DISKETTE FULL If the diskette is full, the diskette symbol flashes in
the status line. No more data are written to
diskette.
Remedy:
Insert a blank diskette before the measurement
data memory of the recorder is also full. If this is
not done, then measurement data will be lost.
PROGRAM DISKETTE This message appears when a program diskette is
inserted in the disk drive and measurement data
have to be written.
Remedy:
Insert the correct diskette, or a blank one.
CONFIG. DISKETTE This message appears when a configuration dis-
kette is inserted in the disk drive and measure-
ment data have to be written.
Remedy:
Insert the correct diskette, or a blank one.