JUMO DICON 401, Operating Manual, Page: 55 / 100

55
10 Configuration level 1
Customized
recalibration
A signal is processed electronically (conversion, linearisation …) to produce a
measured value via the analogue inputs of the controller. This measured value
enters into the calculations of the controller and can be visualised on the dis-
plays (measurement = displayed value).
This fixed relationship can be modified if required, this means that the position
and slope of the measurement characteristic can be altered.
Customized
recalibration
Start value
End value
➔ RECAL
➔ STARTVAL
➔ ENDVALUE
0.
1.
-1999 — 0 to +9999 digit
-1999 — 1 to +9999 digit
(for explanation, see below)
factory-set access code: 0004
Different from all the other
settings, the input of the start and
end values is linked to the present
measured value at the appropriate
input.
These values cannot be readily
accepted by another instrument.
CONFIG 1
➔
INPUTS
➔
ANALOG 1
Parameter Value/selection Description
Factory settings are shown bold .