ENGLISH
13
MAINTENANCE
1.
The tool can be lubricated with a line-mounted lubricating device or manually. During manual
lubrication, disconnect the compressed air supply, apply a few drops of pneumatic oil in the tool’s
air intake and operate the tool for a few seconds. SAE 10 oil or sewing machine oil can be used.
Do not use flushing oil.
2.
Before connecting the air hose, apply 4 or 5 drops of pneumatic oil in the air intake. Do not use oil
with a high viscosity. This can impair tool performance.
3.
Lubricate the tool after every 1 or 2 hours of operation.
4.
Before putting the tool away after use, disconnect the air hose and apply 4 or 5 drops of pneumatic
oil in the air intake. Reconnect the air hose and operate the tool for approx. 30 seconds to
distribute the oil evenly. This will ensure the tool lasts longer.
5.
Clean the air intake filter cartridge each week.
Storage
Do not store in a damp location. This can result in corrosion damage to the mechanism. Always lubricate
the tool before storage.
TROUBLESHOOTING
Problem
Possible cause
Action
The tool operates slowly or
at varying speeds.
The motor is clogged.
The tool starts on its own
when the compressed air
supply is connected.
Low torque.
Abnormal vibrations, the
casing feels hot.
Insufficient air flow (air
pressure too low).
Faulty speed
regulator/trigger.
Worn or damaged rotor
blades.
Dust in the motor.
Defective trigger or trigger
catch.
Air leak at the inlet or
elsewhere.
Bearing damage.
Corresponding O-rings
are worn out or out of
position.
Insufficient lubrication.
Check that the air hose is not
blocked or folded.
Check that the compressor is
supplying the correct air
pressure.
Replace the rotor blades.
Dismantle and clean the tool
as instructed.
Check and repair the trigger
catch and trigger.
Locate and seal the leak as
instructed.
Replace the bearings.
Replace damaged O-rings.
Adjust O-rings that are out of
position.
Lubricate the tool as
instructed until it operates with
the correct speed and torque.
NOTE!
Contact your dealer if you detect a problem that is not included in this troubleshooting guide.
Jula reserves the right to make changes. In the event of problems, please contact our service
department.
www.jula.com
Summary of Contents for Meec Tools 071-024
Page 14: ......