EN
40
13. Ejector opening
14. Catcher
15. Guide for starter cord
16. Top handle
17. Starter handle
FIG. 1
ASSEMBLY
FITTING THE HANDLE
1. Fit the bottom handle on the product with
1 screw (F) and 1 wing nut on each side.
FIG. 2
2. Fold out the top handle and lock in place
by tightening the wing nuts and screws (E).
FIG. 3
NOTE:
Check that the guide for the starter cord is
on the right side of the handle, seen from
behind the product.
POSITION OF STARTER CORD
1. Pull the starter cord through the clamp.
2. Move the engine control lever to the start
position.
3. Hold the starter handle and carefully pull
out the starter cord so that the handle
just goes past the guide. Hook the starter
handle in the guide.
FIG. 4
FITTING THE CATCHER
1. Fasten the grass catcher on the frame by
hooking on all the plastic hooks.
2. Lift up the ejector flap with one hand and
hook on the grass catcher.
3. Release the ejector flap to lock the grass
catcher in place.
FIG. 5
FIG. 6
SIDE EJECTOR
1. Lift up the side guard with one hand and
hook the side ejector on the grass catcher
with the other. Check that both the hooks
have hooked on properly.
2. Release the side guard.
MULCH PLUG
1. Lift up the guard.
2. Press both pins in the holes so that the
mulch plug snaps in place.
3. Release the guard so that it drops down
and covers the mulch plug.
USE
INTENDED USE
The product is intended for mowing lawns in
private gardens. The product must only be used
for its intended purpose and in accordance with
these instructions. All other use is considered
to be unsuitable. The manufacturer is not
liable for any personal injury or damage to
equipment resulting from incorrect use.
The full responsibility for any such personal
injury or material damage rests on the user.
ADJUSTING THE MOWING HEIGHT
IMPORTANT:
Switch off the engine and disconnect the
spark plug lead from the spark plug before
changing the mowing height.
1. The mowing height is adjusted with the
lever for this.
2. Pull the lever out and move it to the
position for the required mowing height.