EN
44
TORQUE SETTING
• Use a suitable torque setting when screw
driving. This reduces the risk of the
workpiece and/or the screw being
damaged.
• When drilling, use the torque setting that
is marked with a drill symbol.
Tip
Always start with the lowest torque setting and
increase if necessary.
MAINTENANCE
NOTE:
Always remove the battery before doing any
work on the tool.
• Clean the tool with a damp cloth. Do not
use petrol, solvents or detergents that can
damage the plastic parts.
• Keep the ventilation openings on the tool
clean.
INSERTING THE DRILL/SCREW BIT
1. Chuck, front part
2. Chuck, back part
FIG. 3
1. Hold the back part of the chuck and twist
the front part.
2. Insert the bit into the chuck until you feel
resistance.
3. Use the adapter for screw bits.
4. Select an appropriate screw bit for the
screw in question.
5. Tighten the chuck by hand and check that
the bit is properly secured.
POWER SWITCH
1. Start the tool by pressing the power
switch.
2. Switch off the tool by releasing the power
switch.
ROTATION SELECTOR
1. Set the rotation selector to
or
.
NOTE:
• Do not touch the rotation selector when
the tool is moving.
• Prolonged use at a low speed increases
the risk of the motor overheating. Avoid
overheating by regularly leaving the tool
switched off for 15 minutes, so that the
motor cools.
SPEED CONTROL
The speed is controlled with the power and
increases steplessly the more the power switch
is pressed in, and decreases when the power
switch is released.
Summary of Contents for Meec tools 003-283
Page 4: ...1 1 2 3 4 5 6 7 2 8 2 1...
Page 5: ...1 2 3...
