EN
12
Straps and clasp
The helmet has a clasp that is easy to fasten
and unfasten without adjusting. The straps
must be evenly tensioned.
1. Put the helmet firmly on the head and
fasten the clasp.
2. Note which straps are loose. Take off the
helmet and shorten the straps to fit.
• To shorten the chin strap, hold the clasp in
one hand. Then pull the strap through the
clasp.
• To shorten the back strap, pull out the
strap from the back of strap 2. Hold the
helmet in one hand. Hold the other hand
in the straps where they pass under the
chin. Pull from side to side to adjust all
four straps evenly sideways.
3. The helmet should sit straight and firmly
on the head.
• To put the helmet lower down over the
forehead, shorten the chin strap and
extend the back strap.
• To put the helmet higher up over the
forehead, extend the chin strap and
shorten the back strap.
FINAL CHECK
Check the tension of the straps by putting the
helmet on the head and fastening the clasp.
Open the mouth wide, the strap should feel
tight against the chin. Try to lift off the helmet
at the front and back. If the helmet can be
lifted off, shorten the corresponding strap and
check that the pads are sufficiently thick. It
should not be possible to move the helmet too
far forwards or backwards.
FIG. 3
MAINTENANCE
CLEANING
Clean the helmet when necessary with hot
water and a mild detergent.
6. Chin strap
7. Lock ring
FIG. 1
A. Front
1. Chin strap
2. Clasp
3. Back strap
FIG. 2
USE
FITTING
The helmet must be well adjusted to provide
full protection. The helmet is properly adjusted
when it does not move forward, backwards or
sideways when fastened. If the helmet can be
wobbled forward or backwards the straps must
be adjusted and/or the pads replaced.
NOTE:
• Check the adjustment of the helmet
every time it is used.
• It should not be possible to take off the
helmet without unfastening the clasp.
• The straps should be adjusted so that
they do not cover the ears and so that
the clasp is turned away from the chin.
• If the helmet cannot be adjusted to suit
the user, use another helmet.
Pads
If the helmet does not fit properly with the
pads inside it, remove them and fit different
sizes of pads. Choose pads of a suitable size
to adjust the helmet to the head of the user.
Different sizes of pads can be used to obtain
the best fit.
