ENGLISH
21
INSTRUCTIONS FOR USE
Thank you for buying our filter pump. We hope you find it easy to install and that it works efficiently. This
filter pump system is made to the most stringent standards and will give you clean, sparklingly clear water
in your new Prompt Set pool or round, oval or rectangular pools with steel frames. The high-capacity
Jilong filter pump combines outstanding filtration with the properties below.
Designed for above-ground swimming pools.
Large volume flow through the filter.
Easy to install and maintain.
Low maintenance and operating costs.
Quiet, high performance.
Quality-accredited
design.
Reliable, corrosion-proof, reinforced materials.
Elegant, attractive design.
Small format – easy and compact to store over the winter.
Filter pump accredited to UL and GS standards.
Safer for swimming and the environment.
This manual contains all the instructions you need to install and use this advanced filter pump system
effectively.
As well as instructions on installation and use, it includes warnings and other important information
relating to safe use of the filter pump system. Read the instructions carefully and show them to anyone
who will be using the pool.
Read the information in the manual carefully before using the filter pump.
INSTALLATION INSTRUCTIONS
1.
Assemble the pool and fill it completely with water as instructed in the pool manual before
assembling and installing the filter pump.
2.
The filter pump operates most effectively when placed at least 20 cm lower than the highest water
level in the pool.
3.
The filter pump must be placed at least 60 cm from the pool wall.
4.
Connect one end of one hose (P27) to the pump's intake port (the upper port) using a hose clamp
(P28).
5.
Tighten the hose clamp properly using a screwdriver.
6.
Connect the other end of the hose (P27) to the lower, protruding hose connection (outlet) in the
pool wall using a hose clamp (P28).
7.
Tighten the hose clamp properly using a screwdriver. Take care not to damage the pool with the
screwdriver.
8.
Connect one end of the other hose (P27) to the pump's outlet port (the lower port) using a hose
clamp (P28).
9.
Tighten the hose clamp properly using a screwdriver.
10. Connect the other end of the hose (P27) to the upper, protruding hose connection (intake) in the
pool wall using a hose clamp (P28).
11. Tighten the hose clamp properly using a screwdriver. Take care not to damage the pool with the
screwdriver.
12.
Open both wall leadthroughs by removing the cap on the inside of the pool. Place a screen in either
leadthrough.
13.
Wait until the pump is full of water. Never run the pump without water.
14.
Carefully turn the air valve cover (P1) 1–2 turns anti-clockwise.
15.
Connect the power cord (P21) to an earthed mains socket with a residual current circuit breaker. If
necessary, contact an authorised electrician to check and/or install a residual current circuit
breaker.
Summary of Contents for 952-007
Page 22: ...ENGLISH 22 ...