ENGLISH
35
5.
Remove the washer and nut from the eye bolt with the rubber duct on the upper part of the crank
for the ejector unit. Place the crank so that the eye bolt comes in the hole on the middle handle.
Lock with the washer and nut.
Use
Check that the mains voltage corresponds to the rated voltage on the type plate. Check before plugging
in the power cord that all screw connections are correctly fitted and tightened, and that the rubber pads
are turned in the right direction.
Power switch
1.
Press the power switch on the side.
2.
Press the drive handle towards the handle with both hands to start the machine.
3.
The machine will not start if this is done in the reverse order.
Moving and snow blowing
Turn the machine by tilting it slightly, so that the wheel on one side acts as a pivot point.
Avoid straining the power cord.
Do not force the machine.
Work smoothly with an even tempo.
Never expose the engine to any other load – risk of material damage.
Always
work
carefully.
Changing the ejector alignment
The ejector alignment can be adjusted by 180° by using the crank for ejector unit.
Summary of Contents for 721-111
Page 37: ......