ENGLISH
33
DESCRIPTION
1. Handle
2. Middle
handle
3. Lower
handle
4. Upper
handle
5. Retaining
screw
6.
Crank for ejector unit, upper part
7.
Crank for ejector unit, lower part
8. Ejector
unit
9. Cover
10. Rotor
11. Rubber
pad
12. Wheel
13. Switch
unit
14. Safety
handle
15. Switch
USE
Before starting
Remove the machine and all the parts from the packaging.
Check all parts for damage. Contact your dealer if any parts are missing or damaged.
The following parts are supplied in a separate bag:
Cable clip
x 3
Crank for ejector unit, upper part
x 1
Crank for ejector unit, lower part
x 1
NOTE:
The upper and bottom parts of the crank for the ejector unit are packed together. Assemble the
machine according to the instructions before use.
Assembly of upper, middle and lower handles
1.
Undo the 4 screws with washers and nuts holding the upper handle to the lower.
2.
Align the screw holes in the middle handle to the holes in the lower handle. Insert the screws with
washers through the holes on each side, and lock with the nuts. Insert the screws from the inside of
the handle, so that the nuts come on the outside.
NOTE:
Do not overtighten the nuts.
3.
Fit the upper handle on the middle handle in the same way as step 2, with the screws, washers and
nuts.
Fitting the ejector unit
1.
Insert the flanges on the ejector unit into the corresponding slots in the cover.
2.
Press down the lower part of the ejector unit.
Summary of Contents for 721-111
Page 37: ......
