ENGLISH
13
If one or more of the lamps does not light, check that:
There is nothing wrong with the mains power supply.
The contact pins in the lamps have penetrated the cable insulation to make contact with the wires.
The light bulbs are intact.
MAINTENANCE
Replacing the bulb
Turn off and disconnect the transformer from the mains supply before changing the light bulb.
Hold the lamp housing in one hand and turn the light unit anti-clockwise until the two sections are
separated.
Pull the defective light bulb straight out of the lamp holder.
Fit a new light bulb (7 watt 12 volt) by firmly holding the bulb and pressing it between the contact
pins of the holder (do not touch the bulb with your bare hands).
Assemble the light unit and the lamp housing and tighten clockwise.
Connect the transformer to the power outlet and turn the power on.
NOTE:
Do not use the lamps if the power cord and/or plug are damaged in any way. For safety reasons,
the power cord must only be replaced or repaired by an authorised service centre. Consult your dealer.
Subject to printing errors and design changes over which we have no control. In the event of problems,
please contact our service department.
www.jula.com
