24
Changing the blade
WARNING
Avoid accidental starting.
Turn off the tool with
the power switch and pull out the power c
ord before
replacing the blade.
•
Open the blade guard
by removing the two screws.
•
Use the hex key to remove the spindle screw while
holding the outer flange in place with the holding
spanner.
•
Remove the outer flange and the blade.
•
Fit the new blade in place
with the arrow showing
the direction of rotation pointing in the same
direction as the arrow on the blade cover.
•
Inspect the new blade for damage.
Replace the
blade immediately if it is cracked or damaged.
•
Re-fit the outer flange and tighten the spindle s
crew
firmly using the spanners.
•
Re-fit the blade guard.
NOTE:
Use only 180 mm wet type cutting blades or
specially designed tile cutting blades. Never use blades
rated for less than 6800 rpm.
MAINTENANCE
WARNING
•
Only use identical spare parts when servi
cing. The use of other parts can cause injury and damage
the tool.
•
Do not carry out any adjustments while the tool is switched on.
•
Turn off the tool and unplug the power cord before making any adjustments, replacing parts,
lubricating or cleaning, or perfo
rming any maintenance.
•
Keep the tool clean.
Cleaning
•
Keep the tool's ventilation openings clean to prevent the motor from overheating.
•
Clean the tool regularly with a soft cloth, preferably after each use.
•
Keep the vents free from dust and dirt. If the dir
t cannot be removed, use a soft cloth moistened
with
soapy water.
NOTE:
•
Keep the tool's ventilation openings clean to prevent the
motor from overheating.
•
Clean the tool regularly with a soft cloth, preferably after
each use.
•
Keep the vents free from dust and dirt. If the dirt cannot be
removed, use a soft cloth moistened with soapy water.
•
Never use solvents such as petrol, alcohol, ammonia
solution, etc.
This can damage the plastic parts.
Summary of Contents for 243010
Page 1: ......
